Siemens CP 1542SP-1 - Diagnostics with SNMP

Diagnostics and maintenance
6.2 Diagnostics with SNMP
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
100 Operating Instructions, 01/2017, C79000-G8976-C426-03
6.2
Diagnostics with SNMP
Requirement
The requirement for using SNMP is the enabling of the function in the configuration, see
section SNMP (Page 45).
SNMP (Simple Network Management Protocol)
SNMP is a protocol for diagnostics and managing networks and nodes in the network. To
transmit data, SNMP uses the connectionless UDP protocol.
The information on the properties of SNMP-compliant devices is entered in MIB files (MIB =
Management Information Base).
You will find detailed information on SNMP and the Siemens Automation MIB in the manual
/6/ (Page 120).
Scope of performance of the CPs
The CPs support the following SNMP version:
●
CP 1542SP-1, CP 1542SP-1 IRC
– SNMPv1
●
CP 1543SP-1
– SNMPv1
– SNMPv3 (with activated Security functions)
Traps are not supported by the CP.
Supported MIBs in SNMPv1
The CPs support the following MIBs:
●
MIB II (acc. to RFC1213)
The CP supports the following groups of MIB objects:
– System
– Interfaces
– IP
– ICMP
– TCP
– UDP
– SNMP
●
LLDP MIB
●
Siemens Automation MIB
Note the rights for writing to the MIB objects, see the next section (SNMPv3).