RUGGEDCOM WIN
User Guide
Chapter 3
Device Management
Loading the Primary Software Version 25
Parameter Description
Current SW Location Synopsis: { 1, 2 }
Displays the number of the memory bank from which the device
software is running.
Primary SW Location Synopsis: { 1, 2 }
Displays the number of the current Primary memory bank.
Primary CDC Displays the filename of the CDC (Customer Defaults Configuration)
file in the Primary memory bank.
Primary UV Displays the filename of the UV (Unique Value) file in the Primary
memory bank.
Secondary SW Version Displays the version number of the software in the Secondary
memory bank.
Secondary SW Location Displays the number of the memory bank selected as the Secondary
memory bank.
Secondary CDC Displays the filename of the CDC (Customer Defaults Configuration)
file in the Secondary memory bank.
Secondary UV Displays the filename of the UV (Unique Value) configuration file in
the Primary memory bank.
Configuration Changes Counter Displays the number of changes made to configuration values on the
device. This value only includes changes to configuration values. It
does not include events, such as setting the primary software image
or uploading a file.
Section3.4.3
Loading the Primary Software Version
To load the Primary software image into the memory bank, do the following:
NOTE
Before performing this procedure, make sure the version in the Current Active Bank parameter is
displayed as Secondary.
1. Navigate to Management» SW Upgrade. The SW Properties screen appears.
To Next Page
Loading...
Need help?
General
