To Next PageTo Next Page
Need help?Do you have a question about the Siemens RWF40.001A97 and is the answer not in the manual?
General| Brand | Siemens |
|---|---|
| Model | RWF40.001A97 |
| Category | Controller |
| Language | English |
Covers safety, fusing, and interference suppression for electrical connections.
Details terminal numbers and connection diagrams for controller outputs.
Explains control for low-heat output from the burner.
Explains operation with a modulating burner using an analog output.
Details operation for a 2-stage burner with an analog output.
Describes setpoint selection and modification using analog signals.
Details switching between SP1 and an external setpoint source.
Explains analog and binary signal influence on setpoint SP1.
Describes how binary signals can shift an external setpoint.
Describes operation for continuous high-heat demand.
Describes operation for a 2-stage burner with a floating output.
Covers automatic safety shutdown procedures triggered by sensor failures.
Details operation with a modulating burner using a floating output.
Sets the threshold for the limit comparator function.
Configuration of analog and binary inputs for sensor and signal types.
Configures limit comparator functions, controller type, and setpoint options.
Sets unit address, decimal place, units, and out-of-range signal behavior.
Defines the start point of the analog input 1 signal range.
Defines the end point of the analog input 2 signal range.
Defines the end point of the analog input 1 signal range.
Defines the start point of the analog input 2 signal range.
Explains the automatic tuning process for PID/PI controllers.
Troubleshooting guide for error indications related to measured value acquisition.
