Siemens RWI65.02 - User Manual

Siemens Building Technologies CM2N3204E / 05.2001
Landis & Staefa Division 1/20
3
204
AEROGYR™
Controller
RWI65.02
for central air handling SW version 3.3
with single-speed or two-speed fans
Compact unit providing control and supervisory functions,
operating voltage AC 24 V, signal voltage DC 0...10 V.
Connection to Landis & Staefa building automation systems by means of
communication cards
In ventilating and air conditioning plants with
• hot water heating coils or electric air heater batteries
• direct expansion cooler batteries or chilled water cooling coils
• recirculated air dampers or heat recovery (HR) equipment
The RWI65.02 is used to:
• Control
– the room-supply air temperature or extract air-supply air temperature (cascade
control) with adjustable minimum and maximum limitations
– the room-supply air temperature or extract air-supply air temperature (cascade
control) with room or extract air-dependent shifting minimum and maximum
limitations (displacement ventilation)
– the supply air temperature
– the CO
2
/VOC content of the room air (demand-controlled ventilation)
– single- or two-speed fans
– air coolers
– chillers
– HR equipment
– hot water heating coils (with preheating)
– electric air heater batteries (with fan overrun)
– circulators in hot or chilled water circuits (load- or outside temperature-dependent)
– air damper actuators (with recirculated start-up circuit for modulating dampers)
– regulating units in hot and chilled water circuits
.
.
.
.
Use

Summary

Technical Design

Control Logic and Configuration

Explains automatic sensor identification, controller configuration (ACC/ASC logic), and P/PI control.

Temperature Control Modes

Frost Protection

Demand-Controlled Ventilation

HR Equipment Anti-Icing

Plant Supervision

Fault Status Signals and Signalling

Fault Signal Legend

Defines the meaning of displayed fault status signals (lines 9 & 10) and their priorities.

Acknowledging Faults

Controller Operation

Setting and Scheduler Levels

DIL Switch Configuration

DIL Switch Settings

Commissioning Notes

Technical Data

Inputs and Outputs

Specifications for digital and analog inputs, outputs, and relay capacities.

Connection Diagram

Wiring Diagrams (Measuring Side)

Wiring Diagram 1: Passive Sensors

Wiring Diagram 2: Active Frost Sensor

Wiring Diagram 3: Active Remote Setting Unit

Wiring Diagram 4: Passive Remote Setting Unit

Wiring Diagram 5: Extract Air Sensor

Wiring Diagrams (CO2;VOC Sensor)

Wiring Diagram 6 & 7: CO2;VOC Measurement

Control Side Connections

Wiring Diagram 8: Control Units

Diagram showing control part with regulating units for heating, cooling, and HR.

Control and Supervision Connections

Wiring Diagram 9: Fault Signals

Diagram showing control and supervision side, including fault signals and relay outputs.

Data Point List

Measured Values and Limitations

List of current measured values and manipulated variables with ranges and factory settings.

Presetting and Control Parameters

Parameter Explanations

Demand-Controlled Ventilation Parameters

Fault Status Flow Diagrams

Incoming Fault Signals

Acknowledged Fault Status

Siemens RWI65.02 Specifications

General

Brand	Siemens
Model	RWI65.02
Category	Controller
Language	English