Siemens S35i - During a Call: Managing Active Calls; Call Control and Management Features

V1.0
16
Disassemble the S35i
A case opener is needed to disengage the latch of the S35i casing.
PHOTO 2.5 C35/S35i CASE OPENER
The part number for this mandatory tool is F30032-P46-A1
Refer to ANNEX B of Chapter 3 for Service Equipment List.
STEP 1 & 2:
Remove the battery cover then the battery as shown in PHOTO 2.6 . Open the housing with the
opening tool and carefully pull the lower housing section off as illustrated in PHOTO 2.7 .
PHOTO 2.6 DISASSEMBLE S35i – STEP 1 PHOTO 2.7 DISASSEMBLE S35i – STEP 2
STEP 3: