Open the housing with the opening tool and carefully pull the lower housing section off as
illustrated in PHOTO 2.11
PHOTO 2.11 Control Board Assy – STEP 1 PHOTO 2.12 Disassemble Control Board Assy – STEP 2
STEP 2:
Unlock the catches of the Display Module from the Control Board and move the display module
to the lower part of the PCB. Lift up carefully the retaining clip of the display connector on the
Control Board as illustrated in PHOTO 2.12
STEP 3:
Remove the Display Module and the Buzzer Sealing from the Control Board as illustrated in
PHOTO 2.13
PHOTO 2.13 Disassemble Control Board Assy – STEP 2
For Remove/Install the display module, watch out for the catches on the display module and the
guide hole of the PCB. For the assembly of the Control Board Assembly just reverse the
sequence for the disassembly.
To Next Page
Loading...
