Functions of the reset button
The reset button has the following functions:
● Restart of the device
To restart the device, press the reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the reset
button, the changes may be lost. If you restart the device using the WBM (menu command
"System > Restart") or using the CLI (command "restart" in the Privileged EXEC Modus),
the configuration changes are always retained.
Upkeep and maintenance
● Loading new firmware
If the "Load & Save" menu command of Web Based Management is unsuccessful, the reset
button can be used to load new firmware. This situation can occur if there is a power outage
during the normal firmware update. You will find further information in the configuration
manual in Downloading new firmware using TFTP without WBM and CLI (Page 41).
● Resetting the device to the factory defaults
The device can be reset to the factory defaults during operation. You will find more detailed
information in the configuration manual in Resetting the device to factory defaults
(Page 40).
NOTICE
Previous settings
If you reset, all the changes you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network with
further consequences.
Description of the device
3.6 Reset button
SCALANCE W760/W720
Operating Instructions, 09/2017, C79000-G8976-C322-08 23
To Next Page
Loading...
Need help?
General
