5.5.2.7 wlan ipcf-ht signal-quality-threshold (access point)
Note
This command is only available with the following KEY-PLUG:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
Description
With this command, you set a signal strength for the client. When scanning the client must
receive the signal coming from the access point with at least the specified signal quality. Only
then is a connection established.
The signal quality is determined by the client based on the RSSI values (Received Signal
Strength Indicator) of received packets. The RSSI value indicates how strong the arriving signal
is and is displayed in the signal recorder.
Requirement
The SCALANCE W700 device is in access point mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● "next channel" is set for the scanning mode.
Syntax
Call up the command with the following parameters:
wlan ipcf-ht signal-quality-threshold <1-5>
The parameter has the following meaning
Parameter Description Range of values / note
- Threshold values
for signal strength
Level
Signal quality in
RSSI %
1 20 40
2 25 50
3 30 60
4 35 70
5 40 80
Result
The signal strength for the client is set.
Functions specific to SCALANCE
5.5 iPCF-HT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
138 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
