Siemens SCALANCE W788-2PRO - Page 142

Configuration Using Web Based Management and the Command Line Interface
Syntax of the Co
C79000-G8976-C184-07
142
mmand Line Interface
CLI\INTERFACES\ETHERNET>
Command Description Comment
ethspeed [A
10F|1
ic selection
by the SCALANCE W788
100F 100 Mbps full duplex
100H 100 Mbps half duplex
10F 10 Mbps full duplex
|100F|100H|
0H]
Specifies the transmission speed
and mode of the Ethernet interface:
A automat
10H 10 Mbps half duplex
ethcross [E|D]
Manual selection of Ethernet
interface crossover. Possible only
when ethspeed is not set to auto.
Operating Instructions SCALANCE W78x