Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
143
6.3.2 W
Enabling t
Network n ly in access point mode)
nter the network name of the wireless network in the SSID text box. If you have
he Basic Wizard, a value is already entered here.
Infrastruct
Select Infrastructure to connect to an access point. Ad hoc is used to connect
clients with each other without an access point. This is only possible when ad hoc
is set on all clients.
Transmiss
Spe
Bas
Not
It is not possible to select the 802.11h protocol in all country settings. It is specified
the comm s active for this country code appears behind the Enable
rior
f signals from a primary user (for example
dar).
LAN Menu Command
he Interface
Enabling interface by selecting Enable Interface.
ame (on
E
used t
ure / Ad Hoc (only in client mode)
ion Mode
cify the transmission mode in the Wireless Mode list box. If you have used the
ic Wizard, a value is already entered here.
e
IEEE 802.11h transmission (only in Access Point mode):
by the configuration of Country code on the System page.
If the 802.11h protocol is selected, after applying the configuration with Set Values,
ent (DFS i
Interface check box.
With the automatically enabled Dynamic Frequency Selection function (DFS), p
to communication, the access point checks whether configured or selected channel
(see Auto Channel Select) is free o
ra
Operating Instructions SCALANCE W78x
To Next Page
Loading...
Need help?
General
