Configuration Using Web Based Management and the Command Line Interface
C79000-G8976-C184-07
159
Syntax of the Command Line Interface
CLI\INTERFACES\WLAN1\802.11G>
or for the second wireless adapter (if it exists)
CLI\INTERFACES\WLAN2\802.11G >
Command Description Comment
ctsmode [0
0 Do not use CTS.
1 Always use CTS.
ending on whether
802.11b
|1|2]
Specifies whether the RTS/CTS
method is used for 802.11g packets:
Available only in the
access point mode.
2 CTS dep
clients exist.
ctsrate [0|1|2|3]
rate for 802.11g
CTS frames:
3 11 Mbps
Specifies the data
0 1 Mbps
1 2 Mbps
2 5.5 Mbps
ctstype [0|1
y
1 RTS/CTS
]
Specifies the method for avoiding
802.11g packet collisions:
0 CTS onl
sslot [E|D]
Enables / disables short
between data packets.
slot times
only11g [E|D]
When this is enabled, only the
OFDM modulation technique is
supported.
Available only in the
access point mode.
overlap [E|D
search for on overlapping channels. access point mode.
]
If this is enabled, 802.11b are also Available only in the
Optimize [1...4]
Specifies the optimization level for
detection of 802.11b clients:
1 IEEE standard method
Available only in the
access point mode.
2...4 proprietary
Operating Instructions SCALANCE W78x
To Next Page
Loading...
