Configuration Using Web Based Management and the Command Line Interface
Command Des
201
cription Comment
rstp_cost <Port>
[0 ... 200000000]
Specifies the path costs for the port
if Version is set to RSTP. If the value
Default value: 0
is 0, the value is calculated.
edgeport <Port> [T|F]
Specifies whether or not an edge
port (T) or a station (F) that supports
spanning tree or rapid spanning tree
is attached to this port. if a (rapid)
spanning tree protocol is received,
the value F is displayed
automatically.
ptpport <po
direct link between two stations. In
this case, you have the following
ort recognizes a PtP port
based on the duplexity. In full
duplex, a PtP link is assumed,
in half duplex no PtP link is
assum dium).
T
F
en
rt> <A|T|F>
The point-to-point link establishes a
options:
A The p
ed (shared me
Specifies a PtP link, even
though half duplex is being
used.
Specifies that there is no PtP
link over the relevant port ev
with full duplex.
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
To Next Page
Loading...
