Approvals, certificates, standards
9.2 Product group X-300M
SCALANCE X-300
230 Operating Instructions, 02/2012, A5E01113043-12
EMC directive (electromagnetic compatibility)
The SIMATIC NET product meets the requirements of the EC Directive:
2004/108/EEC "Electromagnetic Compatibility"
The product is designed for use in the following areas:
Requirements Area of application
Em
ission Immunity
Industrial area EN 61000-6-4: 200
7 EN 61000-6-2: 2005
WARNING
Personal injury and damage to property may occur.
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
● Keep to the installation guidelines
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
● You can always find the latest documentation on the Internet!
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736 (http://support.automation.siemens.
com/WW/view/en/8763736)
– EMC Installation Guideline, Planning Guide
28518276 (http://support.automation.siemens.
com/WW/view/en/28518276)
● Working on the product
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
Note
The produ
ct was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
To Next Page
Loading...
Need help?
General
