Approvals, certificates, standards
9.3 Product group XR-300M
SCALANCE X-300
238 Operating Instructions, 02/2012, A5E01113043-12
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for this
product.
Explosion protection directive (ATEX)
The SIMATIC NET product meets the requirements of the EC directive:94/9/EC "Equipment
and Protective Devices for Use in Potentially Explosive Atmospheres".
WARNING
When using (installing) SIMATIC NET products in hazardous area zone 2, make absolutely
sure that the associated conditions are adhered to:
• "Approval of SIMATIC/ SIMATIC NET Products for Direct Installation in Ex-Zone 2"
You will find this on the Internet on the pages of Siemens Industry Automation Customer
Support under the following entry ID:
33118441 (http://support.automation.siemens.
com/WW/view/en/33118441)
"Entry list" tab > entry type "Certificates"
ATEX code:
II 3 G Ex nA II T4 KEMA 07 ATEX 0145X
The product meets the requirements of the standards
● EN 60079-15 : 2005 (electrical apparatus for potentially explosive atmospheres; Type of
protection "n")
● and EN 60079-0:2006
FM approval
The product meets the requirements of the standards
● Factory Mutual Approval Standard Class Number 3611
● FM Hazardous (Classified) Location Electrical Equipment:
Non Incendive / Class I / Division 2 / Groups A,B,C,D / T4 and
Non Incendive / Class I / Zone 2 / Group IIC / T4
Notice for Australia
The product meets the requirements of the AS/NZS 2064 standard (Class A).
To Next Page
Loading...
Need help?
General
