Approvals, certificates, standards
9.7 Product group XR-300M PoE
SCALANCE X-300
260 Operating Instructions, 02/2012, A5E01113043-12
EMC directive (electromagnetic compatibility)
The SIMATIC NET product meets the requirements of the EC Directive 2004/108/EEC
"Electromagnetic Compatibility"
The product is designed for use in the following areas:
Requirements Area of application
Emission Immunity
Industrial area EN 61000-6-4:2007 EN 61000-6-2:2005
WARNING
Use only approved expansions
The installation of expansions that are not approved for SIMATIC NET products or their
target systems may violate the requirements and regulations for safety and electromagnetic
compatibility.
Only use expansions that are approved for the system.
● Keep to the installation guidelines
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
The very latest documentation is available on the Internet!
You will find the installation instructions documentation on the Internet on the pages of
Siemens Industry Automation Customer Support under the following entry ID:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
ID = 8763736 (http://support.automation.siemens.
com/WW/view/en/8763736)
– EMC Installation Guideline, Planning Guide
ID = 28518276 (http://support.automation.siemens.com/WW/view/
en/28518276)
● Working on the product
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
NOTICE
The product was tested with a devic
e that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
To Next Page
Loading...
Need help?
General
