Approvals, certificates, standards
9.8 MM900 product group
SCALANCE X-300
264 Operating Instructions, 02/2012, A5E01113043-12
EMC directive (electromagnetic compatibility)
The SIMATIC NET product meets the requirements of the EC Directive:2004/108/EEC
"Electromagnetic Compatibility".
The product is designed for use in the following areas:
Requirements Area of application
Em
ission Immunity
Industrial area EN 61000-6-4: 200
7 EN 61000-6-2: 2005
WARNING
Use only approved components
The installation of components, accessories and expansions that are not approved for
SIMATIC NET products or their target systems may violate the requirements and
regulations for safety and electromagnetic compatibility.
Only use components that are approved for the system.
● Installation guidelines
The product meets the requirements if you adhere to the installation and safety notices
contained in this documentation and in the following documentation when installing and
operating the product.
The very latest documentation is available on the Internet!
You will find the installation instructions documentation on the Internet on the pages of
Siemens Industry Automation Customer Support under the following entry ID:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736 (http://support.automation.siemens.
com/WW/view/en/8763736)
– EMC Installation Guideline, Planning Guide
28518276 (http://support.automation.siemens.
com/WW/view/en/28518276)
● Working on the product
To protect the product process from electrostatic discharge, personnel must first
discharge any electrostatic charge from their body before touching the product.
Note
The product was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
To Next Page
Loading...
Need help?
General
