Parameterizing the Mobile Panel
5.7 Configuring operation
Mobile Panels 2nd Generation
102 Operating Instructions, 09/2018, A5E33876626-AC
Requirement
● If you want to restore the factory settings: The HMI device is connected in accordance
with "Connecting a Configuring PC (Page 54)".
● PROFIsafe-based F-system: PROFIsafe communication was terminated.
● The Control Panel is open.
Procedure
1. Open the "OP Properties" dialog using the "OP" icon.
2. Change to the "Device" tab.
3. Click the "Reboot" button.
The following dialog appears:
Button for restoring factory settings and subsequent restart
4. Press one of the following buttons:
– "Reboot": Restart the HMI device immediately.
– "Prepare for Reset": Reset the HMI device to factory settings.
Note
Press "Prepare for Reset" to delete the operating system and project data.
Restore the operating system as described in the section
"Reset to factory settings with ProSave (Page 198)".
– "No": Do not perform a restart, close the dialog.
See also
Desktop and Start Center (Page 87)
To Next Page
Loading...
Need help?
General
