Overview
1.7 Software required
Mobile Panels 2nd Generation
24 Operating Instructions, 09/2018, A5E33876626-AC
Software required
Configuration software
KTP700 Mobile, KTP700F Mobile, KTP900 Mobile, KTP900F Mobile
You need one of the following software products to configure the HMI devices:
● WinCC Comfort V13 SP1 Update 4 or higher
● WinCC Advanced V13 SP1 Update 4 or higher
To operate a fail-safe Mobile Panel in a PROFIsafe-based F-system, you need the optional
package STEP 7 Safety Advanced V13 SP1 or higher.
You need one of the following software products to configure the KTP400F Mobile:
● WinCC Comfort V13 SP1 Update 6 or higher
● WinCC Advanced V13 SP1 Update 6 or higher
You also need the HSP0168 HMI KTP400F Mobile V1.0 or higher.
To operate a KTP400F Mobile in a PROFIsafe-based F-system, you need the optional
package STEP 7 Safety Advanced V13 SP1 or higher.
Configuring a fail-safe Mobile Panel (Page 170)
Terms for fail-safe operation
This section defines terms relating to fail-safe operation with a fail-safe HMI device.
You can find additional information on the topic of "Safety" in the following document:
"SIMATIC Safety - Configuring and Programming" programming and operating manual
(http://support.automation.siemens.com/WW/view/en/54110126
)
To Next Page
Loading...
Need help?
General
