Introduction
1.1 Range of functions
SIMATIC 3964R protocol for Windows 9x/XP/7
6
Installation Manual, 01/2013, J31069-D0131-U001-A2-7218
1.1 Range of functions
The 3964R driver supports the following functions:
● Support of Windows 9x, XP and Windows 7
● 3964R master/slave protocol or Lauf protocol can be selected
● Any COM port can be set in the parameters (COM1 ... COM255).
Up to 4 serial interfaces can be operated parallel to each other.
● Transmission rate: 300 baud to 256000 baud
● 7 or 8 data bits
● 1, 1.5, 2 stop bits
● Parity freely selectable
● The number of send and send start repetitions can be selected
● Buffer size (send/receive) can be set (in each case up to 65536 bytes)
● Timeout times for 3964R/Lauf can be selected
1.2 System requirements
The software was tested with the following hardware. Operating the driver in an environment
with compatible devices is possible without causing problems.
Operating system System requirements
Windows XP
• Processor: ≥ 1 GHz
• Main memory: ≥ 1 GB RAM
Windows 7
• Processor: ≥ 2 GHz
• Main memory: ≥ 4 GB RAM
To Next Page
Loading...
Need help?
General