Siemens SIMATIC IOT2000 Series - Page 22

3 Operating
IOT2000 Setting Up
Version 2.1, 08/2017
21
 Siemens AG 2017 All rights reserved
No.
Action
4.
Change the static IP address of your interface here, if required.
If a DHCP address is required, write “dhcp” to your interface
5.
If you want to change the netmask you have to edit the file “interfaces” in the
directory “/etc/network”
Therefore type in “nano /etc/network/interfaces” and change the netmask for your
interface
After changing do the following:
a. Press Ctrl+X to Exit
b. Press Y to save
c. Press Enter
NOTE
You can use the iot2000setup tool for many other settings. Just have a look at it.