Siemens SIMATIC IPC MD-34A

SIMATIC IPC MD-34A Battery Charger
A5E52426055-AA, 05/2023
3
Powering the battery Charger
WARNING
To reduce the risk of electric shock or damage to your equipment:
• Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
• Disconnect power from the equipment by unplugging the power cord from the electrical outlet.
• Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
CAUTION
Always use the AC adapter that came with the Battery Docking
Perform the following steps:
1. Plug the power adapter with power cord to the battery charger.
2. The charging station beeps when the power input is detected (buzzer default off), and the LED indicator will be on in RED to
show the battery charger is ready to use.
Inserting the Battery Pack
Safety precautions
• Do not operate charger with damaged cord or plug. Have cord replaced immediately.
• Use proper adapters to connect battery charger to power outlet.
• Always unplug the charger if it is not being used.
• Do not expose charger to rain or snow.
• NEVER charge a frozen battery. If battery fluid (electrolyte) is frozen, bring into a warm area to thaw before charging.
• Be sure there is good ventilation in a room where the battery is being charged.
• Do not get the battery wet or immerse it in water.
• The battery should be charged at least every three months to avoid shortening the battery life.
• Do not squeeze or puncture the battery so as to avoid electrolyte leakage of lithium-ion battery.