To Next PageTo Next Page
Need help?Do you have a question about the Siemens SIMATIC NET CP 343-1 ERPC and is the answer not in the manual?
General| Power Supply | 24 V DC |
|---|---|
| Degree of Protection | IP20 |
| Interface | RJ45 |
| Data Rate | 10/100 Mbps |
| Protocols Supported | TCP/IP, UDP |
| Current Consumption | 200 mA |
| Operating Temperature | 0°C to 60°C |
Covers safety notices for SELV, opening the device, and hazardous area usage.
Provides step-by-step instructions for installing and commissioning the CP.
Explains the C-PLUG's role in storing configuration data and its usage.
Details how to replace the CP module, format C-PLUGs, and handle diagnostic signals.
Describes how to change the CP's operating mode between RUN and STOP and access protection effects.
Introduces the ERPC functions and their role in data exchange between S7 stations and ERP subscribers.
Outlines the steps for configuring ERPC functions, including firmware loading and STEP 7 setup.
Covers methods of data transfer (read/write jobs, logical triggers) and frame buffering for ERPC.
Presents a diagram showing ERP subscriber and S7 station connection via Industrial Ethernet for ERPC.
Explains types of read/write jobs and the sequence for ERPC data exchange.
Defines the logical trigger, its implementation via FB56, and conditions for data reading.
Discusses addressing CPU data areas, ERPC symbols, and job size consistency.
Covers the overall ERPC configuration process involving STEP 7 and ILS Workbench.
Details hardware configuration and CP properties setup within STEP 7.
Explains how to create symbol tables and configure ERPC symbols in STEP 7.
Describes the requirements for FB56 and the configuration data block CONF_DB for logical triggers.
Covers the process of downloading STEP 7 configuration data to the CP.
Outlines diagnostic options for ERPC functions using NCM S7 Diagnostics and the diagnostic buffer.
Introduces the two firmware parts: Siemens firmware and ERPC firmware.
Explains the process of downloading ERPC firmware, requirements, and license usage.
Details the requirements and procedure for downloading Siemens firmware using the loader.
Describes error messages found in NCM S7 Diagnostics related to the ERPC application.
