Siemens SIMATIC NET IE FC RJ45 Plug 4x2 CAT 6A User Manual

Frei verwendbar IE FC RJ45 Plug 4x2 CAT 6A
A5E34280610-AA, 08/20
27
7. Pull the remaining wires off the plug.
Releasing the plug
1. Insert the plug into the socket and push the spring down to unlock the plug and release it from the socket again.
2. If there is not enough room, release the plug using a screwdriver (3 mm wide blade).
3. Do not pull on the plug when releasing it.
Replacing the knife cassettes of the stripping tool
Note
Replace the knife cassette if the cut is not clean or after stripping approximately
•
1500 operations on cables with PVC outer jackets
• 150 operations on cables with PUR outer jackets
Note
The insulation piercing contacts of the IE FC RJ45 4x2 CAT 6
A
can be released and
recontacted up to ten times with the same cable cross
-section.
Cable ends that have had a connector fitted, must not be used twice but must be cut
off before
fitting a new connector.

Siemens SIMATIC NET IE FC RJ45 Plug 4x2 CAT 6A Specifications

General

Brand	Siemens
Model	SIMATIC NET IE FC RJ45 Plug 4x2 CAT 6A
Category	Cables and connectors
Language	English