Certification
6.1.2CSA/Sira
The device is marked with a CSA symbol that indicates compliance with both
Canadian and U.S. requirements.
It is specifically approved for use in hazardous locations with the following markings:
• Class I, Division 2, Groups A, B, C, D T4
• Ex nA nC IIC T4 Gc
• Class I, Zone 2, AEx nA nC IIC T4 Gc
The Certificate Body (CB) test certificate is available on SIOS at https://
support.industry.siemens.com/cs/ww/en/view/109794215.
6.1.2 CSA/Sira
When marked with the following ATEX marking, this device is approved for use in
hazardous locations under certificate Sira 15ATEX4262X.
Note
For the maximum ambient temperature, refer to the hazardous location label affixed
to the device.
The device also meets the requirements of the following CSA/Sira standards:
• 2014/34/EU
Directive 2014/34/EU of the European Parliament and of the Council of 26
February 2014 on the harmonisation of the laws of the Member States relating
to equipment and protective systems intended for use in potentially explosive
atmospheres (recast) Text with EEA relevance
• IEC 60079-0, Edition 6.0 (2011)/EN 60079-0:2012/A11:2013
Explosive Atmospheres – Part 0: Equipment – General Requirements
• IEC 60079-15, Edition 4.0 (2010)/EN 60079-15:2010
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection "n"
6.1.3 European Union (EU)
This device is declared by Siemens Canada Ltd. to comply with essential
requirements and other relevant provisions of the following EU directives:
32
RUGGEDCOM RS900
Installation Manual, 04/2022, C79000-G8976-1024-14
To Next Page
Loading...
Need help?
General