Siemens SIMATIC NET RUGGEDCOM RSG907R - Configuring the Device

Device Management
3.2Configuring the Device
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RSG907R console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RSG907R is
https://192.168.0.1.
For more information about available ports, refer to "Communication Ports (Page
27)".
3.2 Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RSG907R interface.
For more information about configuring the device, refer to the RUGGEDCOM ROS
Configuration Manual associated with the installed software release.
26
RUGGEDCOM RSG907R
Installation Manual, 02/2021, C79000-G8976-1387-12