Siemens SIMATIC NET S7-1500 - Page 57

Configuration, programming
4.7 FTP communication
CP 1543-1
Operating Instructions, 12/2019, C79000-G8976-C289-08
57
DONE
ERROR
STATUS
Meaning
0 1 8476
H
Nothing was received from the FTP server. In the current status, an
incorrect response must be assumed.
0 1 8477
H
The specified "Crypto engine" (cryptographic module) was not found.
0 1 8478
H
The attempt to set the selected SSL "Crypto engine" as the default
failed.
0
1
8480
H
A problem has occurred with the certificate of the FTP client.
0
1
8481
H
The specified number could not be used.
0
1
8482
H
The FTP server uses encoding that is not supported.
0
1
8484
H
The maximum file size was exceeded.
0 1 8485
H
The file DB was modified while being processed to be sent or the file
DB is incorrectly structured.
0 1 8489
H
Data could not be sent. There is not enough memory available for the
action on the FTP server.
0
1
8492
H
The file already exists. The file will not be overwritten.
0
1
8496
H
A problem occurred reading the SSL CA certificate.
0
1
8497
H
An unexpected error occurred in the SSH session.
0
1
8498
H
It was not possible to terminate the SSL connection.
0 1 8499
H
The socket is not ready for sending/receiving. Wait until it is ready and
try again.
0
1
8501
H
The SSL certificate check of the FTP server failed.
0 1 8507
H
A timeout has occurred establishing the connection during the active
FTP session while waiting for the FTP server.
0
1
8F54
H
The "EXIST" bit in the file DB header is not set.
0
1
8F55
H
Header status bit: Locked
0
1
8F56
H
The NEW bit in the file DB header was not reset
0 1 8F6B
H
Possible causes:
• Bad value for the CMD parameter
Values from 0 to 15 are permitted.
• An FB40 command is not supported.
Possible cause: Incorrect firmware of the CP
Remedy: Firmware update (with older CPs, use the functions
FC 40...FC 44 instead of FB 40.)
0
1
8F7F
H
Internal error, for example, illegal ANY reference.