Siemens SIMATIC NET S7-1500 - Page 56

Configuration, programming
4.7 FTP communication
CP 1543-1
56 Operating Instructions, 12/2019, C79000-G8976-C289-08
DONE
ERROR
STATUS
Meaning
0
1
8414
H
Error sending data
0
1
8415
H
Specified CMD (command type) was rejected by the client.
0
1
8416
H
Connection was closed by the FTP server.
0 1 8418
H
Error in the user data. Possible causes:
• File name is empty.
• Data length is "0".
• etc.
0
1
8419
H
There is no socket resource available to open a data connection.
0
1
8420
H
There is no socket resource available to open a control connection.
0
1
8421
H
Error opening the file DB to be read
0
1
8422
H
Error opening the file DB to be written
0
1
8423
H
Connection establishment to the FTP server has failed.
0
1
8424
H
Internal error
0
1
8425
H
Format error in the domain name
0
1
8426
H
There are too many DNS queries pending.
0
1
8427
H
The specified DNS server could not assign the specified domain name.
0
1
8428
H
There is no connection resource available.
0
1
8429
H
Unknown channel ID
0
1
8430
H
The file DB is too short.
0
1
8431
H
Error when writing to the file DB.
0
1
8432
H
Error when reading from the file DB.
0
1
8433
H
Error when accessing the file DB.
0
1
8434
H
Action was aborted.
0
1
8435
H
Channel will be reset.
0
1
8436
H
Unexpected server reply
0
1
8437
H
Certificate could not be verified.
0
1
8438
H
Unknown error occurred.
0 1 8439
H
The FTP command causes an error. The cause must be looked for on
the FTP server (REST command).
0
1
8440
H
The FTP server does not support the requested SSL protocol.
0 1 8446
H
After the FTP password was sent to the FTP server, an unexpected
code was returned by the FTP server.
0 1 8451
H
An error was signaled when attempting to change the transmission
mode from binary to ASCII.
0
1
8455
H
A memory request has failed on the CM/CP.
0
1
8460
H
A problem has occurred handling SSL/TLS.
0 1 8469
H
Interface error
The specified output interface could not be used.
Remedy:
Set the interface to be used for outgoing connections.
0 1 8475
H
The SSL certificate or the SSH md5 fingerprint was not considered
trusted.