Certification
CP 443-1 (EX30)
76 Manual, 03/2019, C79000-G8976-C255-05
Siemens Aktiengesellschaft
Division Process Industries and Drives
Process Automation
DE-76181 Karlsruhe
Germany
You will find the EC Declaration of Conformity on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15352/cert)
> Entry type: "Certificates", certificate type: "EC Declaration of Conformity"
The product meets the requirements of explosion protection according to IECEx.
IECEx classification:
● nA
IECEx classification: Ex nA IIC T4 Gc
Certificate no.: DEK 14.0034 X
The products meet the requirements of the following standards:
– IEC 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– IEC 60079-15 (Hazardous areas - Part 15: Equipment protection by type of protection
"n")
● ec
IECEx classification: Ex ec IIC T4 Gc
Certificate no.: DEK 18.0019X
The products meet the requirements of the following standards:
– IEC 60079-0 (Hazardous areas - Part 0: Equipment - General requirements)
– IEC 60079-7 (Hazardous areas - Part 7: Equipment protection through increased
safety "e")
You can see the current versions of the standards in the IECEx certificate that you will find
on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15352/cert)
The conditions must be met for the safe deployment of the CP according to the section
Notices on use in hazardous areas according to ATEX / IECEx (Page 38).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
The product meets the requirements of EC Directive 94/9/EC "Equipment and Protective
Systems Intended for Use in Potentially Explosive Atmospheres" as of 19/04/2016 and the
To Next Page
Loading...
