Notes on installation
5
5.1 Scope of delivery
The scope of delivery includes the following library:
● PCS 7 Basis Library V9.0 SP1
5.2 Hardware requirements
The hardware requirements of SIMATIC PCS 7 version 9.0 HUP02 apply.
Note
CPU_RT block:
The load display in the CPU_RT block is based on use of the system function SFC 78, which
is available as of the standard CPU version >= 5.0, high-availability CPU version >= 4.5 and
the software CPU WinLC RTX. For versions < 5.0 or < 4.5, only the "Stop notification on
overload" function is available.
5.3 Software requirements
PCS 7 Basis Library V9.0 SP1 requires PCS 7 Advanced Process Library V9.0 SP1.
5.4 Installing PCS 7 Basis Library
Exit all applications before you start setup.
Install the library via the PCS 7 master setup or start the program Setup.exe of the PCS 7
Basis Library.
You will receive all further information during the installation process.
The library is copied to the same drive on which the PCS 7 basic software is installed.
Installation requires about 70 MB of free memory on the hard disk.
After the installation, you can find the blocks of the PCS 7 Basis Library in the library "PCS 7
BasisLibrary V90".
In order to receive the delta compilation and delta load capability in your project, use the blocks
from the previous version of the PCS 7 Basis Library.
Please note that in this case you can not use the new features and improvements described
in the section "Notes on documentation".
To update your AS project, copy the blocks to your project.
PCS 7 Basis Library Readme V9.0 SP1 (online)
Readme, V9.0 SP1, A5E42614246-AA 13
To Next Page
Loading...
Need help?
General
