EasyManuals Logo

Siemens SIMATIC RF1040R User Manual

Siemens SIMATIC RF1040R
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Appendix
A.1 Certificates & approvals
SIMATIC RF1000
64 Operating Instructions, 11/2019, C79000-G8976-C432-06
Marking
The EU conformity marking of the electrical equipment according to the ATEX, EMC, RoHS
directive is:
II
3 G Ex ec IIC T
4
Gc
II
3 D Ex tc IIIC T80 °C Dc
TÜV 19 ATEX 225698
Ta.:
-25 °C +55 °C
4.75 5.25 V DC, < 300 mA
Installation and operating conditions for hazardous areas
NOTICE
Notes on installation and use
Note the following conditions when installing, maintaining and operating the device in a
hazardous area:
The permissible ambient temperature range is -25 °C Ta 55 °C.
The RFID readers/writers must be protected against UV light.
EPL Gc: The RFID readers/writers can only be used in areas with degree of pollution 2
or better, as defined in IEC 60991-1.
The RFID readers/writers can only be commissioned in either II 3G or II 3D hazardous
areas. Hazardous areas with mixed atmospheres are not permitted.
During installation, the surface of the metal housing/frame must be smooth and clean.
The RFID readers/writers must be installed in a housing with wall thickness 2-7 mm.
The RFID readers/writers can only be installed in areas with a low risk of mechanical
danger.
The USB/RS232 cable must be secured with the supplied cable ties and adhesive
socket. You can only remove or connect the USB/RS232 cable when the power supply
is switched off or when the device is in an area without flammable gas or dust
concentrations.
The RFID readers/writers should only be cleaned with a damp cloth.
The RFID readers/writers cannot be installed close to charge-generating processes.
EPL Gc: The RFID readers/writers can only be installed in housings with ingress
protection of at least IP54 in accordance with EN 60079-0.
EPL Dc: The RFID readers/writers can only be installed in housings with ingress
protection of at least IP6X in accordance with EN 60079-0.
EPL Gc: It has to be guaranteed that the transient protection is set to a value that does
not exceed 140% of the measured peak voltage value at the USB/RS232 cable of the
housing.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC RF1040R and is the answer not in the manual?

Siemens SIMATIC RF1040R Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC RF1040R
CategoryIndustrial Equipment
LanguageEnglish

Related product manuals