Introduction S5-95U, Second Serial Interface
Conventions
The uniformity of the S5-90U/S5-95U System Manual and the Product Manual ”Second Serial
Interface of the S5-96U Programmable Controller” is assured.
All conventions which are listed in the introduction to the System Manual apply to this Product
Manual. Please refer to the System Manual.
For definitions of the terms ”Warning”, ”Danger”, ”Caution” and ”Note” please see the ”Safety-
Related Guidelines for the User” at the end of this introduction.
Courses
SIEMENS offers extensive training opportunities for SIMATIC S5 users.
For more detailed information please contact your Siemens office.
Reference material
Reference material is listed in the S5-90U/S5-95U System Manual, Appendix E.
Information on the range of devices available for an S5-95U programmable controller is provided in
the following catalogs:
• ST 52.1 ”SIMATIC S5-90U, S5-95U and S5-100U Programmable Controllers
ET 100U Electronic Terminator”
• ST 52.3 ”SIMATIC S5-115U, S5-115H and S5-115F Programmable Controllers”
• ST 54 ”SIMATIC S5-135U and S5-155U Programmable Controllers”
• ST 59 ”SIMATIC S5 Programmers”
• ST 80 ”COROS Control and Process Monitoring Systems”
• IPC 10 ”SICOMP Industrial PCs System Units and Standard Peripherals”
• IPC 12 ”SICOMP Industrial PCs Communications and Process Peripherals”
• PR 30 ”SICOMP M Computer-Systems”
• MOBY-I ”MOBY-I Identification System”
• MP 66 ”TELEPERM M Automation Systems AS 235, AS 235 H and AS 235 K”
Other components and modules (e.g. CPs and SINEC L1) are described in separate manuals. These
sources of information will be referred to in the relevant sections of this manual.
Sheets for corrections/suggestions are included at the end of this manual. Please enter your
suggestions for improvement, additions and corrections in these sheets and return them to us. In
this way, you enable us to improve the next edition.
viii
EWA 4NEB 812 6095-02
To Next Page
Loading...
