Siemens SIMATIC S7 - Page 16

CPU 417-4H
16
A5E00130864-03
English
1. Configuration and Commissioning
Modules that Can Be Used for Fault-Tolerant Systems
In contrast to the master on the PROFIBUS-DP listed in Appendix E of the S7-400H
Programmable Controller; Fault-Tolerant Systems manual, release 07/2001, only the CP443-5
Extended communication processor with the order number 6GK7 443-5DX02-0XE0, as of
hardware version 2 and firmware version V3.2.3, may be used as an external master interface.
In contrast to the specifications in Appendix E, you cannot use the FM 352 electronic
CAM module.
Necessary Versions or Order Numbers of Important System Components
System Component Necessary Versions or Order Number
STEP 7 as of V5.1
H-Optional package as of V5.1
External Master on PROFIBUS DP
CP443-5 Extended
Order No. 6GK7443-5DX02-0XE0 as of
Hardware-version 2 and as of Firmware version
3.2.3
Order No. 6GK7443-5DX03-0XE0 as of hardware
version 1 and as of firmware version 4.0.0.
Redundant DP-Slave-interface module
IM 153-2 and IM 153-2FO
IM 153-2: 6ES7 153-2AA02-0XB0 as of version 7
IM 153-2FO: 6ES7 153-2AB01-0XB0 as of
version 6
DP/PA Coupler IM 157 6ES7 157-0AA81-0XA0 as of version 1 and
Firmware version 3.1.0
Communication module CP443-1
(Industrial Ethernet,
TCP / ISO-Transport)
6GK7443-1EX02-0XE0 as of hardware version 1
and firmware version V5.2
Communication module CP443-1
(Industrial Ethernet,
6GK7443-1EX10-0XE0 as of hardware version 1
and firmware version V1.0.1
TCP / ISO-Transport)
6GK7443-1EX11-0XE0 as of hardware version 1
and firmware version V1.1.0
Communication module CP443-5 Basic
(PROFIBUS; S7-Communication)
6GK7443-5FX01-0XE0 as of hardware version 1
and firmware version 3.1