Siemens SIMOTICS TN N-compact 1LH8 - Page 10

Table 10-3 Spare parts for drive end roller bearings without bearing housing ...........................................117
Table 10-4 Spare parts for roller bearings, DE............................................................................................118
Table 10-5 Spare parts for non-drive end roller bearings with bearing housing .........................................119
Table 10-6 Spare parts for non-drive end roller bearings without bearing housing ....................................120
Table 10-7 Spare parts for roller bearings, NDE ........................................................................................121
Table 10-8 Spare parts for roller bearings with speed sensor assembly ....................................................122
Table 10-9 Additional spare parts for terminal box 1XB1631 with split cable entry.....................................123
Table 10-10 Spare parts for terminal box 1XB9629 ...................................................................................124
Table B-1 Tightening torques for bolted connections with a tolerance of ±10%........................................131
Figures
Figure 3-1 Schematic diagram of rating plate .............................................................................................20
Figure 4-1 Axial fastening of the rotor...........................................................................................................32
Figure 4-2 Schematic representation of a single drive.................................................................................40
Figure 4-3 Schematic representation of a tandem drive...............................................................................41
Figure 5-1 Balancing type on the drive-end side..........................................................................................50
Figure 5-2 Schematic diagram of the water drain holes...............................................................................53
Figure 5-3 Schematic diagram: Aligning the machine to the driven machine...............................................57
Figure 6-1 Water drip loop............................................................................................................................64
Figure 6-2 Terminal box 1XB9269................................................................................................................65
Figure 6-3 Connection with cable lug and fixing screw (schematic diagram)...............................................69
Figure 9-1 Remove the V ring.....................................................................................................................106
Figure 9-2 Disassembling the labyrinth sealing ring (schematic diagram).................................................107
Figure 9-3 Install the V ring.........................................................................................................................109
Figure 9-4 Roller-contact bearing with grease chamber (schematic diagram)...........................................110
Figure 9-5 Position the set screws for the labyrinth sealing ring on the outer bearing cover.....................111
Figure 10-1 Overview of stator and rotor......................................................................................................115
Figure 10-2 Drive end roller bearings with bearing housing.........................................................................116
Figure 10-3 Drive end roller bearings without bearing housing....................................................................117
Figure 10-4 Roller bearings, DE - end shield with integrated bearing cover................................................118
Figure 10-5 Non-drive end roller bearings with bearing housing..................................................................119
Figure 10-6 Non-drive end roller bearings without bearing housing.............................................................120
Figure 10-7 Roller bearings, NDE - end shield with integrated bearing cover..............................................121
Figure 10-8 Speed sensor assembly............................................................................................................122
Figure 10-9 Terminal box 1XB9629..............................................................................................................124
Table of contents
SIMOTICS TN Series N-compact 1LH8
10 Operating Instructions 06/2017