Siemens SINAMICS G120D - Page 45

Installation
3.11 Connections and cables
SINAMICS G120D converter
Getting Started, 07/2016, FW V4.7 SP6, A5E38556189B AA
45
Cable, connectors and tools specifications
The detailed specifications for the cables, connectors and tools required to manufacture the
necessary cables for the SINAMICS G120D are listed in the following tables. The
connections that are detailed in this section relate to the physical connections that exist on
the Inverter. Information for the preparation and construction of the individual connectors
have separate detailed instructions delivered with the ordered parts, direct from the
manufacturers. Use 75° C copper wire only.
Note
NFPA compatibility
These devices are intended only for installation on industrial machines in accordance with
the "Electrical Standard for Industrial Machinery" (NFPA79). Due to the nature of these
devices they may not be suitable for installation accordance with t
he "National Electrical
Code" (NFPA70).
Table 3- 10 Tools
Order number
Crimp tool (Q8/0 and Q4/2)
3RK1902-0AH00
Removal tool (Q8/0)
3RK1902-0AJ00
Removal tool (Q4/2)
Harting part number 0999-000-0305
No special tools are required for the Control Unit connectors
Table 3- 11 Control unit connectors
Connector
Order number
Straight connector
Right-angle connector
24 V DC power supply In (7/8" )
6GK1905-0FB00
3RK1902-3DA00
24 V DC power supply Out (7/8" )
6GK1905-0FA00
3RK1902-3BA00
PROFIBUS In (M12 )
6GK1905-0EB00
3RK1902-1DA00
PROFIBUS Out (M12 )
6GK1905-0EA00
3RK1902-1BA00
PROFINET Port 1 and Port 2 (M12)
6GK1901-0DB20-6AA0
3RK1902-2DA00
Encoder (M12 )
Via KnorrTec
Digital input and output, analog input (M12 )
3RK1902-4BA00-5AA0
3RK1902-4DA00-5AA0
Knorrtec (http://www.knorrtec.de/index.php/en/company-profile/siemens-solution-partner)
Table 3- 12 Push-Pull variant PROFINET and 24 V DC connectors
Connector
Order number
24 V DC power supply
6GK1907-0AB10-6AA0
RJ45 PROFINET
6GK1901-1BB10-6AA0