Siemens SINAMICS G120D - Page 65

Commissioning
4.2 Commissioning with the IOP
SINAMICS G120D converter
Getting Started, 07/2016, FW V4.7 SP6, A5E38556189B AA
65
12.
Select to run or disable Motor Data Identification fun
c-
tion.
This function, if active, will not start until the first run
command is given to the Inverter.
13.
Select either zero pulse on no zero pulse for the a
t-
tached encoder.
If no encoder is fitted to the motor, the option will not be
displayed.
14.
Enter the correct pulses per revolution for the encoder.
This information is normally printed on the casing of the
encoder.
15.
Select the macr
o that is suitable for your application.
Once selected all inputs, outputs, command sources
and setpoints will be automatically configured by the
software.
For further information see the section that details the
precise settings for each macro. Please see
installation
section of this manual.
16.
Set the Minimum Speed at which the attached motor
should run.
17.
Set the Ramp Up time in seconds.
This is the time the Inverter/motor system will take from
being given the run command, to reaching the selected
motor speed.