Siemens SINAMICS V90 User Manual

General information
2.7 Technical data
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
71
Note
•
Continuous operating area is a series of states when a motor can operate continuously
and safely. The effective torque must be located in this area.
•
Short-term operating area is a series of states when a motor can operate for a short
duration if its effective torque is larger than the rated torque.
•
For the motors with different rated and maximum speeds, the output torque will decline at
a faster rate after the speed exceeds the rated speed.
•
The feature in short-term operating area varies with power supply voltages.
•
The continuous operating area becomes smaller and the voltage consumptions on the
cables grow larger when the cables in the major loop exceed 20 m.
Permissible radial and axial forces

Siemens SINAMICS V90 Specifications

General

Power Range	0.05 kW to 7.0 kW
Protection Class	IP20
Communication	USS/Modbus RTU
Feedback	Incremental encoder
Input Voltage	1AC 200 V to 240 V, 3AC 380 V to 480 V
Control Modes	Position, Speed, Torque
Operating Temperature	0 °C to +40°C
Storage Temperature	-40°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m above sea level