What happens when there’s a fire?
5.2 Manual Start
If you see a fire in the machine tool before the fire alarm has been tripped, you can start the
extinguisher system manually using the Manual Start.
Rip off the yellow seal downwards (1).
Firmly hit the red button with your fist (2).
The fire alarm is started.
The communication interface indicates the current status as follows:
System tripped (fire alarm)
(red)
Loss of extinguisher (red)
5.3 Acknowledging the fire alarm
Danger to life!
Always ventilate the rooms thoroughly after the extinguisher system has been tripped! Also
ventilate lower-lying rooms, as carbon dioxide is heavier than air and will flow downwards.
After a fire, the fire alarm must be acknowledged on the communication interface.
Insert the key into the key switch and turn it to the right.
The LED of the fire alarm blinks.
The acoustic signal and the flashing light stop.
The EMERGENCY STOP signal for the machine tool is reset, and the machine can continue
operation.
The key can no longer be removed in this position. If you turn the key back to the left, the signals are
activated and the machine is again switched to EMERGENCY STOP.
The communication interface indicates the current status as follows:
System tripped (fire alarm)
(red)
Loss of extinguisher (red)
To Next Page
Loading...