5. Press this softkey to set up a direct connection between the control
system and the PC.
The following dialog pops up on the screen:
Establishing a network connection
Proceed as follows to establish a network connection:
1. Connect the control system with the local network using an Ethernet
cable.
+
2. Select the desired operating area on the PPU.
3. Press this key to view the extended softkeys.
4. Enter the main screen of the service control options through the fol‐
lowing softkey operations:
→
5. Press this softkey to enter the window for the network configuration.
Note: make sure this vertical softkey is not selected.
6. Configure the network as required in the following window:
Operating in the system data management operating area
3.9 Configuring the Ethernet connection
Diagnostics Manual
42 Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
To Next Page
Loading...
