808D Page 57 Operating and Programming — Milling
Test
Program
s
Content
SEQUENCE
Unit Description
This unit describes how to load the program in “AUTO“ mode and test the
part program at fixed speed.
Unit Content
Program
Execution
Dry Run
Program
Execution
Before the part program can be loaded
and executed in AUTO mode, it must be
tested using the simulation function
mentioned previously!
Press the “Execute” SK on the PPU.
The control is now in AUTO
mode with the current opened
program storage path being
displayed and the AUTO lamp
on the MCP is on.
Now the program is ready to start and the actual operation
will be described in the next section!
End
To Next Page
Loading...
