Siemens SINUMERIK 808D Operating Guide

Operating and Programming — Milling Page 70 808D
Additional
Information
Part 1
s
SEQUENCE
Step 2
Transfer a part program to a PC from the PPU.
Press the “NC” SK on the PPU.
Press the “RS232” SK on the PPU.
Press the “Send” SK on the PPU.
Check the interface setting and start the communication software to
receive the program on PC.
(Press ”Receive Data” on SINUCOM PCIN to start the receive function.)
Use “Cursor + Select” to select the required part program.
The selected program will be highlighted.
The PPU will display a window showing the progress of the transfer.
If there is a problem during transfer of the part program, a window will be
displayed.
You can continue sending the part program.
Press the “OK” SK on the PPU.
Or you can abort the sending of the part program
Press the “Cancel” SK on the PPU.
Step 3
Transfer a part program to the PPU from a PC.
Press the “RS232” SK on the PPU.
Press the “Accept” SK on the PPU.
The PPU will display a window showing the progress of the transfer.
Press “Program Manager” on the PPU.
Check the interface setting and start the communication software to
send the program from PC.
(Press ”Send Data” on SINUCOM PCIN to send data.)
Press the “Copy” SK on the PPU.
+

Siemens SINUMERIK 808D Specifications

General

Brand	Siemens
Model	SINUMERIK 808D
Category	Control Unit
Language	English