Siemens SINUMERIK 808D - Page 74

Operating and Programming — Milling Page 74 808D
Additional
Information
Part 1
s
SEQUENCE
Time
change
You can change the time on the control if required
when the clocks changes from summer time to winter
time.
“Save data” enables the complete system to be
backed up on the system CF card so that there is a
system backup available to the operator.
Press the “Date time” SK on the PPU.
Press the “OK” SK on the PPU.
Make sure the password is set to the “CUSTOMER” access level.
Press “Shift” and “Alarm” on the PPU simul-
taneously.
Enter a new “Date” and “Time”.
Save data
Press the “Save data” SK on the PPU.
Make sure the password is set to the “CUSTOMER” access level.
Press “Shift” and “Alarm” on the PPU
simultaneously.
+
Press the “Cancel” SK on the PPU to
abort the operation.
+