808D Page 9 Operating and Programming — Milling
Switch On
and
Referencing
s
Content
Unit Description
This module describes how to switch the machine on and reference it.
Unit Content
Switch on
the
machine
Reference
the
machine
Please note the explicit switching on rules as specified by
the machine manufacturer.
Turn on the main switch of the machine.
The main switch is usually
at the rear of the machine.
Release all the EMERGENCY STOP
buttons on the machine!
Make sure you perform the following operation!
Step 1
Step 2
End
Switch on
the
machine
End
SEQUENCE
To Next Page
Loading...
