HMI alarms
11/2006 Overview of Alarms
2-683
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
129932 DAT: The configured NCU (%1) for part program %2 in channel %3 is
invalid.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
%2 = Name of the part program
%3 = Channel number
Definitions: The specified combination of NCU, part program and channel is invalid for time measuring of the
configured workpiece.
Remedy: Part program %2 can only be assigned to a channel in an NCU configured in NETNAMES.INI.
129933 DAT: The configured channel (%1) for part program %2 in NCU %3 is
invalid.
Parameters: %1 = Channel number
%2 = Name of the part program
%3 = Name of the NCU according to NETNAMES.INI
Definitions: The specified combination of NCU, part program and channel is invalid for time measuring of the
configured workpiece.
Remedy: Correct the corresponding entry in the DAT file belonging to the workpiece.
129934 DAT: Part program %1 has been configured more than once.
Parameters: %1 = Name of the part program
Definitions: For time measuring of the configured workpiece, the specified part program is configured for several
channels.
Remedy: Correct the corresponding entry in the DAT file belonging to the workpiece.
129935 NC configuration not yet determined.
Definitions: Unable to determine the configuration of the NCs.
Remedy: Ensure that communication to the NC has been activated and all machine data required for time
measuring have been set correctly.
129936 Initialization not yet executed.
Definitions: An order has been sent to the ITS server although the server has not been initialized yet.
Remedy: Execute your operation again later.
129937 Workpiece selection missing.
Definitions: The ITS server has not yet received any DAT file for time measuring, or the contents of the DAT file
is faulty.
Remedy: Select a workpiece for execution prior to executing a time measurement.
129938 Status of workpiece (%1) could not be determined.
Parameters: %1 = Workpiece name
Definitions: The state ?editable? of the DAT file or the workpiece could not be determined.
Remedy: Restart communication to the NC, if required.
129939 Workpiece (%1) is currently being machined.
Parameters: %1 = Workpiece name
Definitions: The DAT file or workpiece is currently disabled.
Remedy: Close the open DAT file or the corresponding workpiece in MCSE, if required.
To Next Page
Loading...
Need help?
General
