Siemens SINUMERIK 810D Diagnostic Manual

Overview of Alarms 11/2006
HMI alarms
2-682
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
129911 %1: Unable to determine machine data
$MN_MM_PROTOC_NUM_FILES[1,10].
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: Machine data MN_MM_PROTOC_NUM_FILES[1,10] of the specified NCU could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129912 %1: Unable to determine machine data
$MN_MM_PROTOC_NUM_ETPD_STD_LIST[1,10].
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: Machine data LINKITEM_MN_MM_PROTOC_NUM_ETPD_STD_LIST[1,10] of the specified NCU
could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129913 %1: Unable to determine machine data
$MN_MM_PROTOC_NUM_ETPD_OEM_LIST[1,10].
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: Machine data LINKITEM_MN_MM_PROTOC_NUM_ETPD_OEM_LIST[1,10] of the specified NCU
could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129914 %1: Unable to determine channel-specific machine data.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: The channel-specific machine data of the specified NCU could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129915 %1: Unable to determine active user for channel %2.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
%2 = Channel number
Definitions: The "active user" of the specified channel of the specified NCU could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129930 %1: Min. %2 log files are required for the requested time determination
($MN_MM_PROTOC_NUM_FILES[%3])
Parameters: %1 = Name of the NCU according to NETNAMES.INI
%2 = Number of log files required
%3 = User index
Definitions: Time measuring of the configured workpiece requires at least the specified number of log files.
Remedy: Set general machine data $MN_MM_PROTOC_NUM_FILES[%3] of NCU %1 to value %2.
129931 %1: Min. %2 ETPD lists are required for the requested time determination
($MN_MM_PROTOC_NUM_ETPD_STD_LIST[%3])
Parameters: %1 = Name of the NCU according to NETNAMES.INI
%2 = Number of ETPD lists required
%3 = User index
Definitions: Time measuring of the configured workpiece requires at least the specified number of ETPD lists.
Remedy: Set general machine data $MN_MM_PROTOC_NUM_ETPD_STD_LIST[%3] of NCU %1 to value
%2.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English