Siemens SINUMERIK 810D Diagnostic Manual

Overview of Alarms 11/2006
PLC alarms
2-820
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
400275 Direct keys 2 failed
Definitions: Direct keys 2: internal timeout has expired.
Reaction: Alarm display.
Remedy: Check connection to direct key module
Program
Continuation:
Internal
400276 Pointer parameter direct keys 1 incorrect
Definitions: Pointer incorrectly defined
Reaction: Alarm display.
Remedy: Correct the pointer
Program
Continuation:
Switch control OFF - ON.
400277 Pointer parameter direct keys 2 incorrect
Definitions: Pointer incorrectly defined
Reaction: Alarm display.
Remedy: Correct the pointer
Program
Continuation:
Switch control OFF - ON.
400551 Fault on MPI/DP bus
Definitions: Error detected on I/O bus
Reaction: Alarm display.
Remedy: Check I/Os, rectify I/O fault
Program
Continuation:
Internal
400552 Fault on DP bus
Definitions: Error detected on I/O bus
Reaction: Alarm display.
Remedy: Check I/Os, rectify I/O fault
Program
Continuation:
Internal
400553 Fault on PROFINET bus
Definitions: Error detected on I/O bus
Reaction: Alarm display.
Remedy: Check I/Os, rectify I/O fault
Program
Continuation:
Internal
400601 Configuration loading points incorrect
Definitions: The PLC configuration in the DB4 does not match the NC configuration
Reaction: Alarm display.
Remedy: Correct tool management start-up
Program
Continuation:
Switch control OFF - ON.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English