Siemens SINUMERIK 810D Diagnostic Manual

PLC alarms
11/2006 Overview of Alarms
2-827
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
428603 Module failure of the DP master
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428604 Failure of a DP slave
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428605 Fault in a DP slave
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428606 Expansion unit recurrence, parameterization error
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428607 DP slave recurrence, parameterization error
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428608 DP slave recurrence, discrepancy between preset and actual
configurations
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.
428621 Module failure, expansion unit slave number %Z
Definitions: OB82 or OB86 has been triggered.
Reaction: Alarm display.
Remedy: Rectify the cause of the error displayed
Program
Continuation:
Switch control OFF - ON.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English