Siemens SINUMERIK 810D Diagnostic Manual

11/2006 List of Action Numbers
3-835
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), Edition 11/2006
No. 18
No. 19
No. 20
No. 21
No. 22
No. 23
Explanation Activate single block (VDI signal: Activate single block)
Cause -
Remedy -
Explanation Deactivation of single block (VDI signal: Activate single block)
Cause -
Remedy -
Explanation Activate main run single block (OPI variable and VDI signal: Activate single block)
Cause -
Remedy -
Explanation Activate decoding single block (OPI variable and VDI signal: Activate single block)
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy − Wait until the preceding ASUB is complete or
− Abort program
Explanation Activate main run single block (OPI variable and VDI signal: Activate single block
Cause -
Remedy -
Explanation Activate traversing single block (OPI variable and VDI signal: Activate single block)
Cause -
Remedy -

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English