Siemens SINUMERIK 810D Diagnostic Manual

List of Action Numbers 11/2006
3-834
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
No. 13
No. 14
No. 15
No. 16
No. 17
Explanation Perform a rapid retraction (VDI signal: Digital-analog interface and ASUB interface, for
further actions see Nos. 10, 11, 12, 85, 86).
Cause -
Remedy -
Explanation Move tool - only with tool management (PI command).
Cause -
Remedy -
Explanation Perform deletion of distance-to-go or axis synchronization (VDI signal: deletion of dis-
tance-to-go or follow-up mode) (follow-up mode: e.g. on activation of axis motion).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program
Explanation Abort repetition of subroutine (VDI signal: Delete number of subroutine repetitions).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program
Explanation Abort subroutine processing (VDI signal: Program level abort).
Cause 1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
Remedy Abort program

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English