Detailed description
2.12 Block descriptions
Basic logic functions: PLC basic program solution line (P3 sl)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
139
PI service: TMFPBP
Function Empty Location search
(dependent on parameter assignment):
For this see the description of FB 7: PI_SERV2 General PI services
PI service: TMGETT
Function Determine T number for the specified tool identifier with duplo number:
Determining the T number for a specified tool identifier with duplo number. The PI-services
stores the T number determined for the tool as result in the variable TnumWZV in the block
TV. If the specified tool does not exist, then the T number "-0001" is returned. Since the PI-
service returns a result in the variable TnumWZV, the service is to be stored with the
semaphore mechanism (PI-service _N_MMCSEM) with the function number for
_N_TMGETT.
Note
Before and after this PI service, the MMCSEM PI service must be called up with the
associated parameter WVar1 for this PI service. See PI service MMCSEM for more
information.
Parameterization
Signal Type Range of values Significance
PIService ANY PI.TMGETT Determining the T
number
Unit INT 1 - 10 TOA
Addr1 STRING max. 32 characters Name of the tool, for
which the T number is
searched
WVar2 INT Duplo number of the
tool, for which the T
number is searched
To Next Page
Loading...
