Siemens SINUMERIK 840C Planning Guide

9 Examples 11.92
9.1.24 Display "Unload to NC program"
Softkey "SELECT"
The following unload procedure types can be selected:
– All magazines
(unloads the tools from all magazines; back-up)
– Magazine ”x” to ”y”
(unloads the tools from a series of magazines)
– Magazine ”x” and chained magazines
(unloads the tools from one magazine and its chained magazines)
– Marked tools
(unloads the marked tools of all magazines)
The type of unloading procedure selected is displayed by a select bit "*".
Softkey ”START”
Activates the function "Unload to NC program". The unloading cycle (L 947) is selected and
NC Start is triggered. The loading program % 9999 must be deleted before the function can
be activated.
9–26
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 840C Specifications

General

Brand	Siemens
Model	SINUMERIK 840C
Category	Control Unit
Language	English